Lanpack update (AREV Specific)
At 22 OCT 1997 07:40:07AM Raymond S Blackwell wrote:
While attempting a system update to three users from a single user Lanpack the following error message occurs: V9 - variable not assigned a value, too many levels etc, the TCL window will not display. Any idea of the reasons or corrective measures required???
Kindest Regards
Ray
At 22 OCT 1997 11:46AM Aaron Kaplan wrote:
You sure that's V9? V9 is countrow, that's why, and it seems like a strange program to break.
What's the version number, as reported by the WHO screen?
At 22 OCT 1997 06:40PM Raymond S Blackwell wrote:
Aarron,
I am endeavouring to update the no of users from 2 to 3 on an Arev 3.12 system. The actual messageis as follows: V9 Line 1, variable has not been assigned a value, zero used
Line 1 V9 broke because a runtime error was encountered.
Press ESC to leave the debugger. Typing END at this point generates the message R18.1 Too many levels of TCL you are limited to 9 levels The TCL window will not display OK, the only exit at this point is a CTRL-BREAK and the OFF at the !.
Hope that this might shed a little light in the darkness.
Kindest Regards
Ray Blackwell