Printing Program (None Specified)
At 27 MAY 1999 11:39:57AM Ray Chan wrote:
Here's a simple questions. I tried to print a stored procedure, Popu_Month, using the System Editor print (Ctrl+P). The program is about 360 lines. I did this about three times. Each time only about half the program is printed.
I am running under NT. Is there a quirk with printing programs under OI? Do I need to do something special under NT? Should I just do a record copy and print the thing under AREV? Do I need to reinstall OI? My Reporter is not working .
Thanks for any tips or comments,
Ray
At 28 MAY 1999 11:58AM Stephen Revelation wrote:
Ray,
Which version, service pack of NT do you have? When you print it, are there any other abnormalities, such as delays, strange printing? Does it just print say, the first three pages (top to bottom), and then simply ends? I'll assume that other stored procedures of that length display similar behavior.
I'm working now on reproducing the problem. Any additional information, such as printer type, drivers would be great.
Thanks,
Stephen Revelation
At 01 JUN 1999 09:54AM Stephen Revelation wrote:
Ray,
Based on the information I currently have, I've not been able to reproduce the behavior you noted. I was able to print the same stored procedure from both of the following configurations on local copies of OI:
1) OpenInsight 3.7, All Networks Driver, NT 4.0 SP 4 Workstation; 64MB RAM using an HP LaserJet Printer with same driver.
2) OpenInsight 3.7.1, Byte Range Locking, NT 4.0 SP 1 Workstation; 32MB RAM using an HP LaserJet Printer with same driver.
So, I can only recommend trying another printer or another printer driver. Besides that, you may find it best to simply cut and paste the procedure into another editor.
Good Luck,
Stephen Revelation